Where is the filter stove on Renault Logan. Where is the cabin filter on Renault Logan

For comfortable driving modern car Complete salon filter. It is responsible for cleaning the air flow entering the inside of the car. Since dust on russian roads Many, the use of the cabin filter is needed.

Unfortunately, not every French car industry is equipped with a cabin filter. 90% auto Renault Logan sold in the territory Russian Federation, do not have this element in your configuration. Ensure independently available or lack of filter is easy.

Designers located salon filter Renault Logan. In the central part of the front panel, closer to the partition motor compartment. You can get to it from the passenger seat. If there is a plastic plug on the air duct, then the car is not equipped with a filtering element. But do not be upset, you can install it with your own hands. About it a bit lower. And now consider the procedure for replacing the salon filter in Renault Logan, if it is in the list of options.

Get to the filter of the car Renault Logan better on the right side

Stages of replacement

If the equipment is equipped with a cabin filter, it changed every 30 thousand kilometers. So it is written in the instruction manual for Renault Logan. But on our roads dust and dirt more than in Europe. Therefore, car repair masters advise to replace the filter element more often, approximately every 15-20 thousand kilometers.

Recall that the cabin filter is located below the front panel in the rear. You can get to it on the right side. For removal special tools No need to flash or lighting lamp. The filter is fixed with one zag.

Order of removal


If you carefully look at the old filter, you can see how much dirt and dust accumulated there. Imagine that this could all be in the cabin and ruined with us on the lungs? Do not save on your health - more often change the filter element.

What to buy?

After reviewing several tens of notes and posts on car forums, we conclude that there is no clear recommendation for the choice and buying a salon filter. Mainly use perfect principle: value for money. The price is higher than that of the usual air filter. Be prepared for this.

The only thing that car owners advise is to use a coal filter element. Such a filter is more expensive, but it cleans the air is much better. It is easy to distinguish it - the filtering harmonic of paper is impregnated with coal composition, therefore has dark gray. The filter cleans the flow of air from dust, shallow mud, microbes, bacteria and enhances the protection of your lungs.

Better to Renault Logan Install a coal cabin filter

For information. Original number Salon filter 7701 062 227. This filter element is also installed on Nissan Micra., Renault Megane. Before buying carefully read the packaging. The box should not be fired. On the package "Right" manufacturer pointed out which models this filter is suitable.

Installing a new filter

  1. Purify air and clean the installation location from contamination.
  2. Remove a new packaging filter.
  3. Somit a little one edge and boot the top of the filter frame in the installation socket.
  4. Watch the filter until it clicks.

The procedure for replacing the salon filter on Renault Logan do it yourself will not be difficult. We offer to see the appropriate video.

Video: Replacing the cabin filter Renault Logan

If there is no salon filter in the configuration

Most cars Renault Logan are not equipped with a filter, but in the case of the air duct there planting place. It is closed by a plastic plug. For independent installation The filter element will be needed:

  • a sharp construction knife with a small blade;
  • canvas hacksaw;
  • sandpaper;
  • cabin filter;
  • one self-tapping screw

So, proceed to the installation:


Differences in the installation on Renault Logan I and II of Generation

A special difference in replacing the salon filter on car Renault. Logan and Renault Logan 2. The location of it is equally. The procedure for performing work is the same.

The only difference that can be seen is a different form of plastic plugs. The embedding procedure and installation is no different.

The cabin filter makes driving comfortable. The cabin accumulates much less dust. If you use coal filtration, then the air quality inside the car becomes noticeably better.

If Renault Logan is not equipped with a cabin filter, we strongly recommend installing it. Modernization of the car to do independently, special skills and skills will not need. And this time will take no more than 30-40 minutes. Good luck!

Today we will talk about freshness of air in the cabin. In the early models, Renault Logan there is no salon filter, and the location under it is closed by a plug. In this article we cut the window for the salon filter and insert it there. The replacement period of the salon filter is 15-20 thousand kilometers.

Vendor code:
Salon filter - 7701 062 227
Tools:
- Metal knife canvas
- Construction knife
Replacing the cabin filter on Renault Logan:
First of all, I will tell you where this cabin filter is located. Sit down on the passenger seat and look at your feet. To the left of the legs, you will see this plug here (if you have not cut it until you).

Now we insert the knife and make a hole to insert a web from the cutter for metal. Next, cut the rectangle. After cut off with a knife, we remove burrs on the sides.


That's what should happen from us. Smooth rectangle without burrs and sharp corners. I do not understand why Renault did not do it from the factory.

Next, bend the cabin filter as shown in the photo to completely entered the hole.


Ready. Salon filter in its place. Insert it until it snaps down.


If you have already had a cabin filter, you can start with the last steps to remove and replace it. You can also purchase a coal cabin filter for cleaner air in the cabin. I wish good luck on the roads! See you!

Salon Replacement Video filter Renault. Logan:

In Logan, the filter is needed as not cool, it is only a pity that it has become only in 2011.

This was done in order to initial savings by the manufacturer. Therefore, in most parts of cars in place where the filter should be a plug.

The filter itself costs - 500 ... 600 rubles. Fortunately, the Logan comes up with many filters from other Renault models.

Below will go instructions on how to cut the cap and build a cabin filter there. This is done similarly as in Renault Sandero. ().

If you are not the first owner probably already someone cut out the plug, if not, then follow the instructions.

The filter compartment in Logan is located under the glove compartment on the left - in the legs of the passenger (in the photo of the Red Arrow).

Lowering the head and leaving the flashlight will see - the compartment under the filter and the plug.


Now we argue with any good cutting and crossing item. Well fit the cloth from the jigsaw, a file, hacksaws or a simple but very sharp knife. Approaches with drill drill all over the seam of small holes with the subsequent catching of the plug. In general, there is a layer of plastics, just do not cut it out.

We cut exactly by seam.


What happened about it.


Now you need to install a pre-purchased filter in the cut hole.


The filter provides a latch. You must install the filter until it clicks. Ready - Logan grinned for a couple of years.

The absence or availability of the cabin filter does not affect any technical specifications car. Its task is completely different - to prevent the dust, sand, soot, pollen into the salon, bacteria, fungi, gases and other elements dangerous to the body. Thanks to the filter in the car, perfectly clean air is maintained, which is especially important for people allergies. Just imagine how much it can turn in the air big City. In the absence of a filter or its malfunction, all this "garbage" is concentrated in the cabin, and then settles in the lungs.

When to change?

Each manufacturer gives its recommendations on the installation of a new cabin filter. In one case, the replacement can be recommended after 10 thousand kilometers, in another - after 30 thousand. But in any case, the emphasis should be done under operating conditions. For example, residents of southern regions, where a large amount of sand prevails in the air, it is necessary to replace the salon every 3-5 thousand kilometers. In the regions where the air is cleaned, the filter element can serve much longer.

In addition, the cabin filter will be much faster to replace the replacement in case of constant trips within the city, in the conditions of dense transport flow. You can only imagine what load has it to withstand this node when there is a car in many hours, almost daily. In such conditions, the filter element must be changed every year, regardless of the car's mileage.

At the same time there are some signs that help to make a decision regarding the need to replace the filter. For example, if fresh and well breathes on the street, and the air is very "heavy" in the car and there are strange smells, it may indicate a filter contamination.

The scored filter element immediately manifests itself when the salon blowing is turned on. Here the diagnosis is simple. The fan operates at full power, but the air outlet is completely not felt. This is explained by the inability of the filtering element to skip through itself large streams.

When one of the above problems and explicit filter contamination, it is necessary to replace it. Many motorists ignore this work and sob their health. It is very important not to save on the filter element and buy only original products. Otherwise, the filter will not fully fulfill its functions and clean the air. You must understand that the high-quality device is able to delay up to 90% impurities. The non-original part will ensure cleaning in best case by 50-60%.

Features of the replacement of the cabin filter on Renault Logan

Many happy buyers Renault Logan are surprised why in their new car it turns out all the garbage and dirty air outside. In fact, it is easy to explain. Most often at the factory-manufacturer, the cabin filter is not installed, but there is a place for it - under the basic second passenger on the right side of the driver. Consequently, your task is to purchase a filter and make it install. If his former owner installed it to you, then you need to know the features of the replacement.

So, the sequence of actions should be as follows:

  1. Buy a new cabin filter for your car. Here you can choose one of several options. For example, give preference to the original coal filter or purchase any other suitable for your model (this moment can be clarified by the consultant in the store). If there are doubts, you can always contact the dealer, where they will give the necessary explanations on this issue. When buying a filter element, make sure that the special plastic lid is available. If this element of the design is not, then the installation of the cabin filter is significantly complicated. It is thanks to the lid that you can consolidate the node in your place.
  2. Prepare required tool For work - a ruler for 30-50 centimeters, a high-quality flashlight (LED), vacuum cleaner (normal or automotive), a sharp knife (scalpel).
  3. Take cutting tool And remove the existing plug with it. This will prepare the opening for the installation of the cabin cleaner. But here you need to be very accurate. Pre-perform the filter measurements that you are going to install and transfer the sizes to the plug itself. Work very carefully, so as not to hook other elements of the ventilation and purification system.

If the opening was already ready and an old filter is installed in it, then remove it. To do this, you must take on the plastic holder (it is at the bottom of the cover) and pull over. After that, make an inspection of an old cleaner. If there are many different garbage, dirt and dust in its intervals, it takes an unambiguous replacement

4. Well, clean the opening of the filter from the existing dirt, unnecessary objects and dust. Make it with a vacuum cleaner. With his absence, you can simply run the stove and give it a little work on maximum power. In this case, it will be possible to remove from the system at least part of the accumulated mud.

  1. Install the new filter element on the prepared place. Return to the place the old filter (even if you perfectly cleaned it) is not recommended. If he serves, it is very long, and it is unlikely to cope with its function.

In the process of installing a new cleaner, slightly squeeze it from above and below, to make the product in the available hole without any problems. At the same time, keep in mind that the first must be recorded, and the second is the bottom of the device.

  1. Make sure that the work is performed qualitatively, and the filter element itself is tightly installed. All that is needed for this is to include blowing and check the quality of the joints.

That's all. Work on the replacement of the salon filter in the Salon Renault Logan is completed.

Output

Believe me, contact the service station to replace the cabin cleaner - this is an extra spending of money. Within 10-15 minutes, you independently install the filter element and you will breathe clean air in the cabin. Good luck.

On the first versions of Renault Logan, the cabin filter was not installed specifically to make the car more affordable, but the ability to install the part was - on the stove box there were special fasteners. After restyling, this detail It appeared in almost all equipment, except for the base. This tradition is preserved in the second generation budget sedan. Renault Logan 2, the filter was installed in all configurations, except for the initial - Access.

This practice is quite common among manufacturers, when one or another options are removed for the reduction of the configuration. This problem also affected the cars of a friendly concern - AvtoVAZ, Lada Largus models were forced to install these details on their own. In other cases, if this option is already provided, it will be necessary to spend no more than 10 minutes to replace and install a new consumator.

According to the service regulations, replacing the cabin filter on Renault Logan is not less common than once a year or when the planned one is passed, which occurs every 15,000 mileage kilometers.

But at the same time it is possible to periodically pay attention to the fact that in some cases the replacement may be required much faster:

  • When operating a car in summer on dusty areas, the filtering element is much stronger thances for small dust, as a result of which the replacement may be required after 6-7 thousand mileage kilometers.
  • With frequently simple in traffic jams, the element is clogged with small particles of soot exhaust gasesAs a result, it may appear to be relatively clean, but the surface acquires gray color, indicating strong pollution, and permeability decreases almost to zero.
  • In the autumn period, foliage is possible in the air ducts - even a small amount can start rotting and will become a rampant stand of millions of bacteria causing nasty smell. It is quite difficult to get rid of it, it will take not only the replacement of the filtering element, but also full cleaning of the box.

Choosing a new Renault Logan filter.

The manufacturer releases 2 parts for its models - 272775374R and 272773016R for the first and second generation of sedan, respectively. Since 2015, cars are installed updated model 272773151R. The main difference in the presence of a coal filler, which makes the work of the element more efficient. These models are original and do not differ depending on the type of engine and configuration. But their cost is quite high - from 700 rubles, which makes it look for more accessible analogues.

The most popular analogues for the first / second generation of sedans, respectively, are:

  • Bosch 1987432120/1987435011,
  • FILTRON K1152 / K1321,
  • MANN CU1829 / CU22011,
  • MAHLE LA230 / LA923.

Also, if you need to install a filter on a car Renault Logan 2 generations in basic configuration It is necessary to buy a plug, article 272763745r.

How to replace the cabin filter Renault Logan 2

All work on installing a new element is made in a few simple actions:

  • Need to click on the latch of the lid, which is located behind the glove compartment from the passenger side,
  • Torx20 screws are unscrewed, with which the compartment lid is attached,
  • I pull out the filter, just pulling it around the edge.

To install a new element you need to surrend him a bit in such a way that it is freely entered into the compartment. It is necessary to make sure that it is installed in the right direction. For this, special arrows are applied to its body, showing how the air should pass through it.